We all grasp the situation of gear reducer, we can take a look at the advantages of mechanical equipment in the specific use of the whole process, we all use gear reducer in the operation of the situation, we master gear reducer operation must pay attention to what matters?

The matters needing attention in gear reducer operation are as follows:

1: When installing the gear reducer, attention should be paid to the center line alignment of the transmission device management department, and the error of the gear shaft of the reducer should not exceed the compensation amount of common couplings. High quality alignment can improve service life and obtain ideal transmission device with high efficiency.

2: According to the requirements of the installation of machinery and equipment, to ensure that workers can easily and quickly close to the oil level gauge, vent plug, drain plug. After timely installation, the accuracy of installation position and the clamping efficiency of each standard part should be checked in multiple directions in order, which should be able to rotate flexibly after installation. The reducer adopts oil pool splash lubrication. Before operation, customers need to remove the oil plug from the vent and replace the vent plug.

3: When installing the transmission parts of the gear reducer on the output shaft, it is not allowed to knock the three-phase gear reducer motor with a drill. Generally, the installation fixture and the external thread of the bearing end cover are used, and the transmission parts of the large reducer are embedded with the anchor screw, otherwise the internal parts of the reducer may be damaged. When we all operate the gear reducer, we must pay more attention to the above problems. We must operate our gear reducer in a proper way.

The difficult problems in installing the gear reducer are as follows:

1. When installing the gear reducer, we should pay attention to the center line alignment of the transmission device management office, and the error should not exceed the compensation amount of common couplings.

2. When installing the transmission parts on the output shaft, it is not allowed to knock with a drill. Generally, the installation fixture and the external thread of the bearing end cover should be used, and the transmission parts should be embedded with the anchor screw, otherwise the internal parts of the reducer may be damaged.

3. According to the requirements of the installation, to ensure that workers can easily and quickly close to the oil level gauge, vent plug, drain plug. After timely installation, the accuracy of installation position and the clamping efficiency of each standard part should be checked in multiple directions in order, which should be able to rotate flexibly after installation. The gear reducer adopts oil pool splash lubrication. Before operation, customers need to remove the oil plug from the vent and replace the vent plug.

When we are installing and using gear reducers, we should all pay attention to the above matters. It is only when we operate gear reducers in proper ways that we should attach great importance to them.